NewsExplainer
Even several kilometers from an airport, altitude limits can apply. Check “airport surrounding airspace” on DroMap
Airport restrictions are not limited to the area right next to the runway. Several restriction surfaces, such as approach and horizontal surfaces, can impose altitude limits under the Civil Aeronautics Act even at distant points. Tap a location on DroMap and the result sheet shows whether it falls in airport surrounding airspace, with an estimated altitude limit.
The Civil Aeronautics Act defines up to six kinds of restriction surfaces (obstacle limitation surfaces) around airports: the approach surface, transitional surface, horizontal surface, conical surface, outer horizontal surface, and extended approach surface. In the area beneath these surfaces, there is an upper limit on height. Along the extension of the takeoff and landing paths, or within the horizontal and conical areas that spread out from the runway, the affected area can reach several kilometers from the runway, not just the area right next to it. Being far from the airport does not necessarily mean you are fine.
Depending on the location, several of these surfaces may overlap and apply at the same time. In that case, the altitude limit that actually applies at that point is the lowest value among the overlapping surfaces. Even a place away from the takeoff and landing paths themselves is subject to an altitude limit if it falls within the area that a conical or horizontal surface spreads over. So do not judge by the distance from the runway alone; check each location before you fly.
When you tap a location on the DroMap map and it falls in airport surrounding airspace, the result sheet shows an “Airport” chip and an “Airport surrounding airspace” row, with the names of the surfaces that apply (for example, conical surface or approach surface; up to 3 when several apply, followed by “and others”). It also shows “Maximum altitude you may fly here (estimate)”: the height above ground, obtained by subtracting the ground elevation from the limit altitude given above mean sea level (AMSL), together with the original AMSL value. Where several surfaces overlap, a note says it is the lowest of the overlapping surfaces. Contact details for the airport administrator may also be shown (up to 2). This check is performed whether or not the “Airport surrounding airspace” layer is displayed. You can switch the colored display on the map with the “Layers” button (on a smartphone, it is among the buttons at the top right of the screen).
This altitude figure is a reference value calculated on DroMap’s servers. The “limit altitude” shown by DIPS and by official airport inquiry systems is stated as an elevation above mean sea level, whereas DroMap also shows the height above ground, calculated by subtracting the ground elevation from the AMSL limit. The ground elevation comes from GSI (Geospatial Information Authority of Japan) data. The notation differs, but the limit itself does not change. Still, we cannot rule out errors in the display or calculation.
Check results are for reference only. Before you fly, always confirm with official sources such as DIPS 2.0 (MLIT’s online drone application system).
This is an English translation of the Japanese original. If the two versions differ, the Japanese version prevails.